• DVI-D Dual Link Cable
• Ideal for use as an LCD monitor cable or DVI projector cable
• Dual Link connection supports resolutions of up to 2560 x 1600
• Connectors: DVI-D Dual Link Male to DVI-D Dual Link Male
• 10 Year Warranty

• DVI-D Single Link Cable
• For use as an LCD monitor cable or DVI projector cable
• Single Link connection supports resolutions of up to 1920 x 1200
• Connectors: DVI-D Single Link Male to DVI-D Single Link Male
• 10 Year Warranty

• DVI-I Single Link Digital + analog Cable
• For use with all standard digital TFT (Thin Film Transistor)/LCD (Liquid Crystal Display) Flat Panel Displays
• Single Link connection supports resolutions of up to 1920 x 1200
• Connectors: DVI-I Single Link Male to DVI-I Single Link Male
• Also available in lengths of 1, 2 and 5m.
• 10 year warranty

Just one of our huge range of DVI cables and DVI leads. For connecting DVI devices at distances of over 10m, use our Super Long Distance DVI Cables.

A guide to DVI is also available.

• VI-D Single Link Male to DVI-D Single Link Male
• For use with all modern digital monitors, projectors and TFT/LCD Flat Panel Displays
• UXGA (1600 x 1200) and HDTV1080i (1920 x 1080) compatible
• RF-BLOK shielded design
• 10 Year Warranty

LINDY Super Long Distance DVI cables use a specially developed and optimised cable material that allows longer cable distances than the 7.5m maximum recommendation laid down by the DDWG (Digital Display Working Group).

Please note: Maximum supported distances and resolutions are dependent on both the monitor and the chipset used in the graphics card.

Features of the RF-BLOK shielded design:

• Reduced interference from one piece EMI (Electromagnetic Interference)/RFI (Radio Frequency Interference) shield

• Increased insulation resistance up to 25%

• No soldering requirements as interconnect design needs no 360 degree soldering - eliminating the possibility of human error and/or cracking of the solder that causes grounding intermittence and the use of the most hazardous waste material - soldering flux

• Tight fit of internal wires as there is no inner mould

• No requirement of ferrite cores as signal loss and degradation are greatly reduced giving enhanced signal sharpness. Without the ferrite cores the cable is less stressed and more flexible

• Smaller overall dimensions which allows more room behind the host or peripheral

• Increased connector and mating strength - the 4 point reinforcement tabs on the RF-BLOK, attached to the connector, strengthens the pair as one